how to wire a 4 prong ignition switch

When it comes to maintaining a two-wheeled vehicle, there are many things to consider. One of the most essential aspects of this process is understanding how to wire a 4G ignition switch. This task isn’t as daunting as some riders might assume, but it does require an understanding of the parts involved and a few safety precautions. With the right tools, anyone can do it.

The first step in wiring a 4G ignition switch is to make sure that all the tools needed are in one place. This includes wire cutters, electrical tape, various sizes of screws, and a screwdriver or drill with appropriate bits. Then, the rider needs to locate the wire harness that passes from the battery to the ignition switch. This harness should include a red power wire, a black ground wire, green ignition wire and purple/orange/yellow accessory wires.

Next, the rider will need to remove the metal casing of the 4G ignition switch to access the alternator terminals. These terminals will be labeled “IGN 1”, “IGN 2”, “ACC”, “GROUND” and “POWER”. The rider should then properly attach the wires in their correct position, beginning with the red power wire attached to the “POWER” terminal, the black ground wire to the “GROUND” terminals and the green ignition wire to the “IGN 1” and “IGN 2” terminals. Finally, the purple/orange/yellow accessory wires should be connected to the “ACC” terminal and secured with electrical tape, ensuring they will not make contact with any other terminals. Once all the wires are connected, the rider can replace the metal casing and turn the key to the on position to test the 4G ignition switch.

By following the outlined steps, any rider should be able to successfully wire a 4G ignition switch. With a few safety precautions and the right tools, it is a relatively straightforward process. With the wiring complete, riders can now continue with their vehicle maintenance and keep their four-wheeled life going.

How To Wire Ignition Switch What Wires Go Rx Mechanic