how to install a hundred amp sub panel

Installing a hundred amp sub panel is a fairly simple and straightforward process that any homeowner can do with the proper tools and knowledge. Sub-panels are designated areas of electrical power that provide an additional source of electricity to a house or building, usually by means of a circuit breaker. In cases where a homeowner needs more power than their main panel provides, a sub-panel can be a great solution. Here is how to properly install a hundred amp sub panel.

The first step in installing a hundred amp sub panel involves gathering all of the necessary materials and tools. This includes a 100 amp sub panel, wire cutters, wire strippers, electrical tape, screwdrivers, pliers, and a voltage tester. Once you have all of the materials and tools ready, shut off the power from the main panel and locate the area in which the sub-panel will be installed. Ensure that there is enough space for the panel and all the wiring.

Using wire cutters and strippers, strip off the insulation from the cable wires, then twist them together in order to attach them to the terminals on the sub-panel. Once the cable wires are attached, use electric tape to wrap up the exposed connections, then use the voltage tester to ensure that the connections are made correctly. Finally, use the screwdrivers and pliers to secure the cover onto the back of the sub-panel. After completing all of these steps, your hundred amp sub-panel should be successfully installed and ready for use.

Installing a hundred amp sub panel may seem intimidating at first, but following the steps outlined above should make it much easier. Before beginning, be sure to take all of the necessary safety precautions and make sure to consult an electrician if you feel uncomfortable with any part of the installation process. With these helpful guidelines, you can safely and effectively install a sub panel and enjoy the convenience of an additional source of power.

Wiring 100 Amp Service To My Detached Garage The Journal